Your purchase of these products through affiliate links helps to generate commission for, at no extra cost. The unit of this value is lqi.(Many of the links in this article redirect to a specific reviewed product. The minimal value is 0 and the maximum value is 255. It's not possible to read ( /get) or write ( /set) this value. Value can be found in the published state on the linkquality property. Value can be found in the published state on the action_duration property. The possible values are: on_press, on_press_release, on_hold, on_hold_release, up_press, up_press_release, up_hold, up_hold_release, down_press, down_press_release, down_hold, down_hold_release, off_press, off_press_release, off_hold, off_hold_release. Value can be found in the published state on the action property. The minimal value is 0 and the maximum value is 100. Value can be found in the published state on the battery property. Remaining battery in %, can take up to 24 hours before reported. The action_brightness_delta indicates the delta for each interval. If this device provides a brightness_move_up or brightness_move_down action it is possible to specify the update interval and delta. Simulated_brightness: Simulate a brightness value. Legacy: Set to false to disable the legacy integration (highly recommended), will change structure of the published payload (default true). How to use device type specific configuration This device supports OTA updates, for more information see OTA updates. Allow joining of new devices in Zigbee2MQTT.Use zigbee2mqtt/bridge/request/device/remove to remove the device from the network (this should result in a "left the network" log message).However, nothing happens when a button is pressed (no light, no log message in Zigbee2MQTT). The dimmer appears to be working normally and the logs in Zigbee2MQTT look good. # Device announces itself but the buttons don't work applying zigbee2mqtt/bridge/request/device/remove to a dimmer) result in timeouts, perform a reset (see above) and apply the action right after the device announced itself in the network. Method 2: Use a needle or paperclip to press the reset button on the back for 10 seconds.The device will flash green and red alternatively after which it will reconnect to the network. When the light turns green, release the buttons. Method 1: Press all four buttons for 4 seconds.Use the dimmer as source and a literal coordinator as target for that. If you want to bind the dimmer to a (Hue) lamp you'll have to bind it to the lamp through MQTT and unbind it from the coordinator. This method also works for Philips Hue Lightstrips, IKEA Trådfri, Sonoff ZBMINI, and Tuya light bulbs. To use the Hue dimmer switch to factory reset a Hue light bulb see HOWTO: Factory reset a Hue bulb open in new window. Your device should now be discoverable by your network.After about 10 seconds both your Zigbee device and the Hue dimmer should flash.Take the dimmer and hold the ON and OFF buttons close to your device for approximately 10 seconds.Many devices can be factory reset / re-paired with a help of Hue dimmer switch: # Using the dimmer to reset other Zigbee devices You can let go when the light on the front flashes red/green briefly. Restart the Hue dimmer switch by holding all 4 buttons of the Hue dimmer switch. Battery, action, action_duration, linkqualityįactory reset the Hue dimmer switch by pressing and holding the setup button on the back for 10 seconds.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |